5-1
NO. TOOL
1
Box driver 10mm
13mm
19mm
Heater (1)
Motor (1), Balance (5), 2 holes of each left and right of the
shock absorber 1 Pulley hole
2
Open End wrench 10, 13,19mm Replaceable for the box driver.
Since the bolt runs idle when the box driver is used, use the
box driver 17mm.
3 Vice pliers Tool to protect the idle and abrasion of the bolt for the
box driver.
4 Other(Driver, Nipper, Long nose) General tools for the after service.
5 JIG for the Tub 1 (Disassemble and Assemble)
5. ASSEMBLY AND DISASSEMBLY
5-1. TOOLS FOR DISASSEMBLY AND ASSEMBLY
To Next Page
Loading...
