6-1. TROUBLE DIAGNOSIS
Water is not supplied
Is the water supply hose
connected normally?
Connect the water supply hose.
- Connect the hot and cold water hose.
NO
Is the water facet open?
Check the water facet valve.
- Connect the hot and cold water valves.
- Check whether the water is not disconnected.
NO
Is the Water Valve normal?
Check the Water Valve.
- Remove any alien particles in the Valve Filter part.
- Check the Valve Coil resistance.
Check whether you hear a “Woong” sound.
- Replace the Value when you have other problems.
NO
Is the connected condition of
the Wire normal?
Check the connected condition of the Wire.
- Check whether the Wire is disconnected.
- Check whether there is any housing missing or Pin deviated.
NO
Is the water level sensor normal?
Check the Pressure.
- Check whether there are any breaks on the pressure hose or
whether the Pressure Hose is pulled out.
- Replace the Pressure Sensor if there are any problems after
checking.
NO
Replace the Main PCB.
To Next Page
Loading...
