Problem What To Do
Will Not Start
•Plug the unit into the wall outlet. Check for proper voltage.
• Check fuse or reset circuit breaker.
• Push any key to turn on the washer and press the Start/Pause key to run the
washer.
• Close door and push the Start/Pause key to run the washer.
• Check if washer is in a pause, soak or suds process. Wait briefly and it may
start. (If the washer is in suds period, Suds will light up instead of remaining
time.)
• Check for restricted drain system. (If there is electrical problem in drain system,
“nd” error will occur after 15 minutes.)
• Check Water Supply.
• Check the line or water valve screen filter.
• Check if PCB connectors are assembled properly.
• Check if CN2 terminals on PCB are in good condition. (Refer to PCB Connector
Check.)
• Replace PCB.
Leaking
• Make sure inlet hose connections are not leaking. Check for rubber gasket
damage due to over tightening.
• Check standpipe for leak. Wrap a dry rag around the standpipe opening. If rag
becomes wet, leak is fault of home plumbing. Be sure the standpipe is capable of
accepting the flow of water from the washer.
• Make sure end of drain hose is correctly inserted and secured to drain
standpipe.
• Check internal hose connections (fill, drain systems, dispenser hoses &
clamps).
• Check rubber boot. Remove, reposition and reinstall, if necessary.
• Check for possible kinked dispenser to outer tub hose. Hot water pressurization
may force door open.
5.SVC Information ( Troubleshooting)
45
To Next Page
Loading...
