Q. When I went back to my washer, it was
turned off. What happened?
A. Power button may have been accidentally bumped or pushed.
Reset the cycle and start the washer. Make sure the unit is
plugged into a live electrical outlet. Check house fuse or
circuit breaker.
Q. The washer door gets locked after a
power failure. How can I open it?
A. If the power fails while the door is locked, the door will remain
locked until the power comes back on. If the power comes
back on while the door is still locked, the cycle will resume
where it left off. If the door is unlocked, “PF” will display and
the washer will pause. Press Power Off and restart the cycle.
Q. The washer door does not unlock when
there is water in the tub. How can I
open it?
A. The water must be drained from the tub for the door to be
opened. Set the rotary dial to Spin Only and press the
Start/Pause dial. The door will open 2-3 seconds after the
Spin or Drain cycle is completed.
6.Reference Information
6-5. Q & A
59
To Next Page
Loading...
