Samsung WF42H5000 - Inverter Board Testing; Motor Connector Test; Hall Sensor Connector Test; Communication Connector Test

Motor
Connector
Communication
Connector
Hall Sensor
Connector
Step 1: Put your black lead on the stator motor CN6 Pin1 and Red lead measure CN2 pin 1- 2 -3 -4 all
measurements should be approx 4.6.
Step 2: Put your black lead on the stator motor CN6 Pin 1 and Red lead measure CN1 pin 1-2-3 all
measurements should be approx 4.6.
Step 3: Move the black lead to CN6 Pin2 and repeat steps above.
Step 4: Move the black lead to CN6 Pin3 and repeat steps above.
All measurements should be around 4.6 ohms.
Checking the Inverter Board Test 1