Samsung WF45H6300A - Self Clean

English _31
SELF CLEAN+
Self Clean+ is a self-cleaning cycle that removes mold that may occur inside the washing machine.
1. Press the Power button.
2. Press the Self Clean+ button.
• OncetheSelfClean+buttonispressed,the
only function that can be set is Delay End.
3. Press the Start/Pause button.
• WhenyoupresstheStart/Pausebutton,Self
Clean+ begins.
• Using Self Clean+, you can clean the drum, tub and diaphragm without using a cleansing
agent.
• Never use Self Clean+ when laundry is in the washing machine. It may cause damage to the
laundry or a problem with the washing machine.
• Ifyouwanttouseadrumcleansingagent,useonly1/10oftheamountofthedrum
cleansing agent recommended by the cleansing agent manufacturer. (When using a
powder type cleansing agent , remove the liquid detergent compartment.)
The Self Clean+ Auto Indicator Function
• Ifthe“Self Clean+” button is lit after a wash, it indicates
that tub (drum) cleaning is required. In this case, remove
the laundry from the washing machine, turn the power on,
and clean the drum by running Self Clean+.
• IfyoudonotrunSelfClean+afterevery40washes,the
“Self Clean+” indicator turns o after one hour. However,
the “Self Clean+” indicator will light again after five
washes. Not running Self Clean+ at this point will not
cause a problem with the washing machine.
• AlthoughtheSelfClean+AutoIndicatorappearsoncea
month or so, the frequency may dier depending on the
number of times the washing machine is used.
04 maintaining your washer
CAUTION
WF45H6-03385A_EN.indd 31 2014-1-10 9:26:42