EasyManua.ls Logo

Samsung wf45h6300aw - Troubleshooting and Error Codes; Error Mode Identification

Samsung wf45h6300aw
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22 _ Troubleshooting
4. TROUBLESHOOTING
4-1. ERROR MODES
► This is a washer integrated error mode. For detailed information, refer to the general repair scripts.
Error Type For USA Causes Remarks
Water Level
Sensor
1E
- Thepartofthehosewherethewaterlevelsensorislocatedis
damaged(punctured).
- Thehoseiscloggedwithforeignmaterial.
- Thehoseisfolded.
- Toomuchlubricanthasbeenappliedtotheinsertionpartofthe
airhose.
- Hoseengagementerror.(disengaged)
- Partfault.(Faultyinternalsoldering)
- Thewaterlevelsensorterminalisdisengaged.
- MainPBAfault.
Motor Driving
Error and Hall
Sensor Error
3E
- ThePBAconnectorterminalisnotconnected.
- Themotorspinnetisnotengaged.
- Themotor’sinternalcoilisdamaged.(short-circuitedorcut)
- Thehallsensorterminalisnotconnected.
- Foreignmaterial(ascrew)hasenteredthemotor.
- Motoroverloadedduetotoomuchlaundry.(Non-sensing)
- Themotorhallsensorterminalisnotconnected.
- PBAfault.
- ThemotordrivingerrorfromthePBAisweak.
Unstablerelayoperation,etc.
- Thisoccursduetoerroneousoperatingsignalsfromthemotor
hallsensor.
- TheIPMterminalofthemainPBAisnotconnected.
- TheDDmotorcoverisoutofplace.
- ThePCBhousingterminalisnotconnected.
- PBAfault.
- DDmotorfault.
Thiserroroccurs
becauseofrestrained
revolutions.
Thiserroroccurswhen
an interference is
generatedduetotoo
muchlaundry,etc.
Water Supply
Error
4E
- Foreignmaterialisenteringthewatersupplyvalve.
- Thewatersupplyvalveterminalisnotconnected.
(Wiredisconnected)
- Thewarmwaterandrinseconnectorsarewronglyconnected
toeachother.
- ThisoccursifthePCBterminalfromthedrainhosetothe
detergentdrawerisnotconnected.Checkwhetherthe
transparenthoseisfoldedortorn.
4E2
- Thecoldandwarmwatersupplyhosesarewronglyengaged
intoeachother.
- Thetemperatureofthewatersuppliedthroughthedryvalve
duringadrycycleissensedashigherthan70˚C.
- Thewatertemperatureissensedashigherthan50˚Cinthe
WoolorLingeriecourses.
Thewatersuppliedfor
1minutedryingthe
dryingcycleis0.3~
0.4L.
Drain Error 5E
- Thepumpmotorimpellerisdamagedinternally.
- Thewrongvoltageissuppliedtotheparts.
- Partfault.
- Thisoccursduetofreezinginthewinterseason.
- Thedrainhoseisclogged.(Injectionerror,foreignmaterial)
- Cloggedwithforeignmaterial.
- Thewaterpumpterminalisnotconnected:rubberband,bills,
cotton,hairpins,coinshavecollectedinsidethedrainpump
ASSY.

Related product manuals