6_ installation
installation
Electrical supply and grounding
AC 230 V / 60 Hz fuse or circuit breaker is
required.
• Use an individual branch circuit specific to the
washing machine.
• Do NOT use an extension cord.
• Use only the power cord that comes with the
washing machine.
• Do NOT connect the ground wire to plastic
plumbing, gas lines, or hot water pipes.
• Do not remove or modify the grounding pin of
power cord to reduce the risk of electric hazard.
• Please use the additional grounding wire provided
with this appliance if there is no hole for earth pin
in power inlet socket.
Environment
• Leave some space.
Space at last 15 cm between the washer and the wall.
• Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak surface,
noise or vibration may be occured. (Allowable is 2°)
• Never install the washer near water.
Do not place the washer in steamy rooms or
where the washer is directly exposed to rain.
Moisture may destroy the electrical insulation
and cause an electrical shock hazard.
• Avoid direct sunlight or heating devices.
As plastic and electrical components are affected
by direct heat, never place the washer near heaters,
boilers,etc. Do not place under direct sunlight.
How to clean the filter (in case drain pump)
1. Place a rag under the washer filter not to wet the floor.
2. Rotate the filter counter clockwise and pull out the filter.
3. Remove dirts and rotate the filter clockwise until it
locks in position.
Should be cleaned Filter at least 1 time a week.
Open
Close
Filter
Rag
Connecting the supply hose
(Insert the supply hose
into washer)
(Insert the supply hose
into faucet)
Connecting the drain hose
Without pump: Insert the drain hose(a) and push it
tighly to be connected as arrow direction.
With pump: Install the drain hose(A) about
70~80cm above the ground for pump model.
70~80cm
cleaning the machine
Cleaning the lint filter
If the dregs are filled up in the lint filter after finishing
the wash, push down(1) and pull it out(2) as shown
in figure.
Remove the collected lint and rinse the filter net.
Lint filter
Cleaning the wash tub
Wipe off strains on the cabinet and operation panel
with soft cloth.
Do not use benzene, thinners, cleanser, or wax, nor
scrub the washer with a brush. Painted surfaces or
plastic parts will be damaged.
WARNING
WT16J8PEC_DC68-03040B-07_EN.indd 6 3/26/2020 8:02:57 PM
To Next Page
