INSTALLATION
ENVIRONMENT HOW TO CLEAN THE FILTER (In case drain pump)
3ODFHDUDJXQGHUWKHZDVKHU¿OWHU
Leave some space QRWWRZHWWKHÀRRU
6SDFHDWODVWFPEHWZHHQWKHZDVKHU 5RWDWHWKH¿OWHUFRXQWHUFORFNZLVH
DQGWKHZDOO DQGSXOORXWWKH¿OWHU
3. Remove dirts and rotate
3ODFHWKHZDVKHURQDVWXUG\ÀDWVXUIDFH WKH¿OWHUFORFNZLVHXQWLOLW
If the washer is placed on an uneven or weak locks in position.
surface, noise or vibration may be occured. Remark : Should be cleaned
(Allowable is 2°) Filter at least 1 time a week.
Never install the washer near water. CONNECTING THE DRAIN HOSE
Do not place the washer in steamy rooms or Insert the drain hose(a) and push it tighly to be
where the washer is directly exposed to rain. connected as arrow direction.
Moisture may destroy the electrical insulation
and cause an electrical shock hazard.
Avoid direct sunlight or heating devices.
(WITHOUT PUMP)
As plastic and electrical components are
affected by direct heat, never place the
washer near heaters, boilers,etc.
Do not place under direct sunlight. Install the drain hose(A) about 70~80cm above the
ground for pump model.
CLEANING THE MACHINE
CLEANING THE LINT FILTER
,IWKHGUHJVDUH¿OOHGXSLQWKHOLQW¿OWHUDIWHU
¿QLVKLQJWKHZDVKSXVKGRZQDQGSXOOLW
RXWDVVKRZQLQ¿JXUH
5HPRYHWKHFROOHFWHGOLQWDQGULQVHWKH¿OWHUQHW
OVERFLOW FILTER
3XOOWKHXSSHUVLGHRIWKHRYHUÀRZ¿OWHUZLWK
WZR¿QJHUVLQWRWKHKROH¶$¶LQWKHGLUHFWLRQRI
DUURZDVVKRZQLQWKH¿JXUH
3
Lint Filter
CLEANING THE WASH TUB
Wipe off strains on the cabinet and operation panel
with soft cloth.
Do not use benzene, thinners, cleanser, or wax, nor
scrub the washer with a brush.
Painted surfaces or plastic parts will be damaged.
CLEANING THE COVER WINDOW SPIN
1. Rotate the cover window spin clockwise
and pull out.
2. Cleaning the cover window spin.
3. Insert the cover window spin back and
rotate it counterclockwise until locks in
positon.
Remark : Should be cleaned the cover window spin
at least 1 time a month.
Close
Open
Cover Window Spin