WASHING PROCEDURE
TO WASH
...................................................................................................................................
1. Before starting washing, check the following;
- Connect the water supply hose and open the
water tap.
- Connect the power cord to the power supply
outlet.
- Lay the drain hose(A) down toward a sinkhole.
(WITHOUT PUMP)
- Place the drain hose(A) in sink or bath about
70~80cm above the ground.
(WITH PUMP)
2. Set the WASH SELECTOR
KNOB to the desired mode.
3. Set the CYCLE SELECTOR KNOB to ‘WASH
.
RINSE’.
(In case no drain pump.) (‘WASH’ In case drain pump.)
4. Set the WATER SELECTOR
KNOB to WASH .
5. Load laundry in the wash
tub.
6. Fill water in the wash tub
and add the detergent.
7. Set the WASH TIME 1-15
minutes.
8. After washing,set the
CYCLE SELECTOR KNOB to
‘DRAIN’ for drain.
SPIN DRY
...................................................................................................................................
1. Transfer the clothes into the spin basket 3. Close the spin dryer lid.
and arrange the clothes evenly.
2. Be sure to attach the safety cover and close the
inner lid.
4. Set the AIR TURBO SPIN TIMER 1-10
minutes.
5. Incomplete spining.(Severe vibration or
unbalance) See “When you load ...”on
page 6.
(WITHOUT PUMP)
(WITH PUMP)
4