Samsung WT80J8 - Rinsing

1. Set the CYCLE SELECTOR KNOB to
‘WASH RINSE’.(In case no drain pump.)
(‘WASH’ In case drain pump.)
3. Set the WASH TIMER 2~3 minutes.
4. Drain the water.Set the CYCLE SELECTOR KNOB
to ‘DRAIN’.
5. Repeat this cycle until drain water is clean. (2~3
cycles)
6. In case no drain pump.
- Be sure lay the drain hose down.
In case drain pump.
- Be sure place the drain hose in sink or bath.
RINSING
.....................................................................................................................................
2. Supply the proper amount of water as not to
RYHUÀRZWKHWRSRIWKHZDVKLQJWXE.
OVER FLOW RINSE
..................................................................................................................
1.Keep suppling water
Adjust water pressure to ensure that
the amount of water supplied does not
exceed that water drained.
3. As soon as the WASH TIMER shuts off, turn off
the water tap.
2. Set the WASH TIMER
6~8 minutes.
4. Set the CYCLE SELECTOR
KNOB to ‘DRAIN’.
ADDITIONAL RINSE
.................................................................................................................
1
2
3
6
5
4
5
(WITHOUT PUMP)
(WITH PUMP)
(WITHOUT PUMP)
(WITH PUMP)
After rinsing you can select this course for more effective rinse (Don’t select only this course for rinse.)
Load the laundry evenly After stopping water
into the spin basket. supply, cover the
laundry with safety cover
and close the inner lid.
Set the WATER SELECTOR KNOB to (b) Close the spin dryer lid.
SPIN(a) and CYCLE
SELECTOR KNOB to (a)
‘DRAIN’.(b)
Supply water for about 1minute. Set the AIR TURBO
$GMXVWWKHZDWHUÀRZWRSUHYHQW SPIN TIMER 2~3 minutes.
RYHUÀRZIURPWKHZDVKWXE