English16
Installation
• Verify the detergent and softener compartment openings, turn the caps to open, and then fill with detergent and
softener up to the MAX line.
• Do not use a mixture of a detergent and a softener.
• Always keep the detergent container with the cap closed.
Setting the amount of detergent/softener input
Follow these instructions to increase or decrease the amount of detergent/softener dispensed automatically.
Eco 40-60
For optimal performance
Eco 40-60
For optimal performance
Dose per Wash
‘OK’ to set auto dispense
Med.
1. Tap .
2. Turn the Navigation dial to select Dose Per Wash or Dose Per Rinse.
• Dose Per Wash: You can select the amount of detergent to input.
• Dose Per Rinse: You can select the amount of softener to input.
3. Tap O to change the setting.
• Default setting is Med., and you can select from Med., High, Off, or Low.
Setting the water hardness/softener concentration level
Eco 40-60
For optimal performance
Eco 40-60
For optimal performance
Water Hardness
OK’ to set the hardness level
Med.
1. Tap and hold for 3 seconds.
2. Turn the Navigation dial to select Water hardness or Softener.
3. Tap O to change the setting.
• The default setting for Water hardness is Med. Changing the setting adjusts the amount of detergent dose.
Water hardness setting Soft Med. Hard
Amount of detergent dose Decreased Normal Increased
• The default setting for Softener is 1x. Changing the setting adjusts the amount of softener dose.
Softener setting 1x 2x 3x
Amount of softener dose Normal Decreased Even more decreased
B-PJT_WASHER-AD_SimpleUX_SG_DC68-04409S-00_EN.indd 16 2022-06-15 11:17:46
To Next Page
Loading...
