EasyManua.ls Logo

Samsung WW10TP34DSG - Page 36

Samsung WW10TP34DSG
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting _ 33
No. Information Type
Information
Code
Causes Corrective Actions
14 Power
UC
(9C)
- Powerconditionfault.
- Thisoccurswhenunderorovervoltageissupplied.
- Extensionleadorplugadapterisbeingused.
- MainPBAfault(sometimes)
•Checkthepowersupply,
polarityandvoltage.
•Selectahotwashordrycycle
(wdonly),measurethevoltage
suppliedduringheating.(Aerror
occurswhenundervoltageis
detected.)
*Safetyensuresafeworking
practicesobservedwhentesting
liveappliance.
•Checkifasocketoutletadaptoris
beingused.
•MainPCBfault(sometimes)
15 Mems PBA 8C
- ErrordetectedintheMemsPBAordataerror
detected.
•Checkthewireconnections.
Replaceifnecessary.
1.Checkthewireconnections.
2.ReplacetheMemsPBA.
3.MainPBAwireconnection
errororPBA’ssilvernanopart
malfunction.
Replaceifnecessary.
16 AddDoor
DDC
- AswitchcontacterrorbecauseofdamagetotheAdd
Doorswitch.
- Whentheadddoorispulledbyforce.
- Thisoccursinthehotwashbecausetheadddooris
pushedduetoapressuredifferencefrominternal
temperaturechanges.
- S/WcontactfaultbecauseofLIDTC“L”
transformation.
•Adddooropen/closeswitchfault.
•MainPCBfault.
DC3
- TheAddDoorlockswitchterminalisconnected
incorrectly.
- TheAddDoorlockswitchterminalisbroken.
- ThisoccursduetoLowinsualtionofthewiringassy.
- MainPCBfault.
•Adddoorlockswitchfault.
•MainPCBfault.
17
Detergent
DrawerMotor
6C
- Autodetergentdispensemotorconstrain
- Autodetergentdispensemotorwiring
- Autodetergentdispensemotornotoperate
•Checkmotoroperationby
pressingthelaundrywhenyou
enterautodetergentdispenser.
•IfnotoperationchangeASSY
PUMP DRAIN.
18 Auto Dispense
6C1 - Theinputarrestofthedetergentmotorissensed.
Checkthewireandifnecessary
replaceit.
1.CheckWireconnection
2.ReplaceAssyPump
6C2 - Thenon-operationofthedetergentmotorissensed.
6C3 - Theinputarrestofthefabricsoftenermotorissensed.
6C4
- Thenon-operationofthefabricsoftenermotoris
sensed.
6C5 - Themotormotionperceptionsensorfault
6C6 - Thedetergentlevelperceptionsensorfault
6C7 - Thefabricsoftenerlevelperceptionsensorfault

Related product manuals