English 23
Installation
3. Hold the adaptor and turn part (C) in the
arrow direction to loosen it by 5 mm (*).
4. Insert the adaptor onto the water tap, and
then tighten the screws while lifting the
adaptor.
5. Turn part (C) in the arrow direction to tighten
it.
6. While pulling down part (D) on the water
hose, connect the water hose to the adaptor.
Then, release part (D)
adaptor with a clicking sound.
7. To complete connecting the water hose, see
2 and 3 on the “Connecting to a threaded
water tap” section.
NOTE
• After connecting the water hose to the adaptor, check if it is connected properly by pulling the
water hose downwards.
• Use a popular type of water taps. If the tap is square-shaped or too big, remove the spacer ring
before inserting the tap into the adaptor.
WW3000TM(SEC)_IM_Hongkong_8C104-000991_EN.indd 23 2022-05-02 11:29:42
To Next Page
Loading...
