English 47
Troubleshooting
Problem Action
Stops.
• Plug the power cord into a live electrical outlet.
• Check the fuse or reset the circuit breaker.
• Close the door and press the Start/Pause button to start the washing
machine.
For your safety, the washing machine will not tumble or spin unless the
door is closed.
•
noises to check the door lock and does a quick drain.
•
washing machine may start.
•
•
washing machine temporarily will not drain or spin. As soon as the
Fills with the wrong
water temperature.
• Fully open both taps.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct taps. Flush water lines.
• Make sure the water heater is set to supply a minimum 120 °F (49 °C) hot
water at the tap. Also, check the water heater capacity and recovery rate.
•
clogged.
•
as the automatic temperature control feature checks incoming water
temperature. This is normal.
•
water going through the dispenser when cold or warm temperatures are
selected.
This is a normal function of the automatic temperature control feature
as the washing machine determines the water temperature.
Load is wet at the end
of a cycle.
• Use the High or Extra High spin speed.
•
• Load is too small. Small loads (one or two items) may become
unbalanced and not spin completely.
• Make sure the drain hose is not kinked or clogged.
WW3000TM(SEC)_IM_Hongkong_8C104-000991_EN.indd 47 2022-05-02 11:29:48
To Next Page
Loading...
