10 S&C Instruction Sheet 662-505
Installation
Cable Terminations
STEP 4. To facilitate makeup and connection of cable
terminations to the switch terminals, switch
interphase and end barriers (where applicable)
can be removed by loosening the wing-head
screw that secures each barrier to the barrier-
support angle.
(a) Remove the tie wraps that secure the wing-
head screws for shipment. The screw will
remain attached to the barrier, which is
supported at the switch frame by the barrier
guide. See Figure 5 on page 9.
(b) Lift the barrier from the guide and place it in
a location where the barrier will not be
damaged.
STEP 5. Optional cable guides (catalog number sufx
“-M2”or “-M3”), if specied, include cable-
support brackets (packed separately) and
mounting angles (factory-installed when an
optional base spacer, 12-inch minimum, is
specied; packed separately otherwise).
(a) Using the hardware furnished, attach the
mounting angles (if packed separately) to
the tabs provided on the sidewalls of the
compartments and attach the cable-support
brackets to the angles. See Figure 5 on
page 9.
(b) Do not remove the protective sheet from the
saddle of the bracket or install the cable
wrap until instructed to do so in Step 6 on
page 12.
To Next Page
Loading...
