Need help?Do you have a question about the Sanden SD-709 and is the answer not in the manual?
Safety procedure for relieving internal pressure before disconnecting lines.
Guidelines for safe refrigerant recovery and recycling to prevent atmospheric discharge.
Personal safety precautions for handling refrigerant, including eye and hand protection.
Importance of working in a well-ventilated area when handling refrigerants and oils.
Precautions for handling R134a refrigerant and PAG oils, emphasizing moisture sensitivity.
A chart to diagnose and remedy common compressor symptoms and problems.
Methods for checking refrigerant leaks using visual inspection, soap bubbles, and electronic detectors.
Procedures for checking and measuring compressor oil level in the vehicle.
Procedure for draining, measuring, and refilling oil for internally repaired compressors.
Methods to determine the correct oil charge for systems with long hoses or large refrigerant capacities.
Detailed procedure for replacing the lip type shaft seal and associated components.
Instructions for removing the cylinder head and inspecting gaskets.
Procedure for removing the valve plate from the cylinder block and inspecting reeds.
Steps for installing the valve plate and cylinder head, including gasket preparation and torquing.
Methods for testing the Thermal Protector Switch (TPS) for continuity and actuation temperature.
Safety procedure for relieving internal pressure before disconnecting lines.
Guidelines for safe refrigerant recovery and recycling to prevent atmospheric discharge.
Personal safety precautions for handling refrigerant, including eye and hand protection.
Importance of working in a well-ventilated area when handling refrigerants and oils.
Precautions for handling R134a refrigerant and PAG oils, emphasizing moisture sensitivity.
A chart to diagnose and remedy common compressor symptoms and problems.
Methods for checking refrigerant leaks using visual inspection, soap bubbles, and electronic detectors.
Procedures for checking and measuring compressor oil level in the vehicle.
Procedure for draining, measuring, and refilling oil for internally repaired compressors.
Methods to determine the correct oil charge for systems with long hoses or large refrigerant capacities.
Detailed procedure for replacing the lip type shaft seal and associated components.
Instructions for removing the cylinder head and inspecting gaskets.
Procedure for removing the valve plate from the cylinder block and inspecting reeds.
Steps for installing the valve plate and cylinder head, including gasket preparation and torquing.
Methods for testing the Thermal Protector Switch (TPS) for continuity and actuation temperature.
General| Refrigerant | R134a |
|---|---|
| Rotation | Clockwise |
| Voltage | 12V |
| Clutch Diameter | 132 mm |
| Pulley Type | Fixed |
| Pulley Outer Diameter | 132 mm |
| Mount Type | Bracket |
| Maximum RPM | 6000 RPM |
To Next Page
