Need help?Do you have a question about the Sanden SD7B10 and is the answer not in the manual?
Safety procedures for relieving pressure before system disconnection.
Guidelines for safe and legal refrigerant recovery.
Safety precautions for handling refrigerants, including PPE.
Importance of working in well-ventilated areas with refrigerants.
Warning against using compressed air due to contamination risks.
Precautions for handling R134a refrigerant and PAG oils.
A chart to diagnose and resolve compressor problems.
Procedure for draining and refilling oil after internal compressor repair.
Oil charge determination for TXV systems with less than 56 oz refrigerant.
On-vehicle testing for oil charge in TXV systems with over 56 oz refrigerant.
Continuation of oil charge determination for TXV systems with over 56 oz refrigerant.
Procedure for replacing the lip type shaft seal assembly.
Continuation of lip type shaft seal replacement steps.
Steps for removing the cylinder head from the compressor.
Steps for installing the valve plate and cylinder head.
Detailed steps for converting R-12 systems to R134a.
Continuation of steps for R-12 to R134a system conversion.
Safety procedures for relieving pressure before system disconnection.
Guidelines for safe and legal refrigerant recovery.
Safety precautions for handling refrigerants, including PPE.
Importance of working in well-ventilated areas with refrigerants.
Warning against using compressed air due to contamination risks.
Precautions for handling R134a refrigerant and PAG oils.
A chart to diagnose and resolve compressor problems.
Procedure for draining and refilling oil after internal compressor repair.
Oil charge determination for TXV systems with less than 56 oz refrigerant.
On-vehicle testing for oil charge in TXV systems with over 56 oz refrigerant.
Continuation of oil charge determination for TXV systems with over 56 oz refrigerant.
Procedure for replacing the lip type shaft seal assembly.
Continuation of lip type shaft seal replacement steps.
Steps for removing the cylinder head from the compressor.
Steps for installing the valve plate and cylinder head.
Detailed steps for converting R-12 systems to R134a.
Continuation of steps for R-12 to R134a system conversion.
General| Brand | Sanden |
|---|---|
| Model | SD7B10 |
| Category | Air Compressor |
| Language | English |
To Next Page
