5
Before you begin, be sure to shut your computer down and disconnect the power cable.
This process will dier depending on whether you are installing your new SanDisk SSD in a desktop or
Replacing your HDD
Notebook Computer SSD Installation
NOTE:
instructions).
3. Remove any brackets or adapters attached
to the current HDD and install them on your
new SanDisk SSD in the same way as they
were on your current HDD. (Note: This step
may not apply to every install, not all
notebook hard disk drives have additional
brackets or adapters.)
4. Align the connector pins on your SanDisk
SSD with the pins on the SATA connector in
the drive bay and carefully place the SSD
into the drive bay. (Note: Be sure to firmly
connect the SSD connector pins with the pins
on the SATA connector in your notebook
drive bay.)
6. Replace your battery and power cable, then power on your notebook computer.
is complete.
…And that’s it! Enjoy the speed of your new SanDisk SSD!
To Next Page
Loading...
