15
Safety Warnings
When using electrical appliances, basic
precautions should always be followed,
including the following:
• Read all the instructions and retain
this instruction manual.
• Ensure that all electrical connections
(including the mains adapter and
power cable) are properly made and
in accordance with the manufacturer’s
instructions. Switch o and withdraw
the mains adapter before making or
changing connections.
• Consult your dealer if you are ever
in doubt about the installation,
operation or safety of your unit.
• Do not allow the unit to be exposed
to dripping or splashing.
• Never store in hot or very cold
areas. Recommended operating
temperature is 0~40°C.
• Do not use the unit in areas with high
moisture (e.g. bathroom) or dusty
areas.
• Do not place hot objects or naked
ame sources such as lighted candles
or night lights on or close to the unit.
High temperatures can melt plastic
and lead to res.
• Do not obstruct the ventilation
openings of the unit with items such
as newspapers, tablecloths, curtains,
etc. Overheating will cause damage
and shorten the life of the unit.
• Do not handle the power cable with
wet hands.
• Be careful with the LCD panels on
the unit.
• Only use attachments/accessories
specied by the manufacturer.
• When the unit is not in use or
unattended for a long period of time,
disconnect it from the mains socket.
• Do not remove any xed cover as this
may expose dangerous voltages.
• Do not continue to operate the unit if
you are in any doubt about it working
normally, or if it is damaged in any
way - switch o, withdraw the mains
adapter and consult your dealer.
• Never let anyone especially children
push anything into holes, slots or any
other opening on the case - this could
result in a fatal electrical shock.
• Route the power cable so that it is
not likely to be walked on, crushed,
chafed, or subjected to excessive
wear, tear or heat.
Note about LCD screen
The LCD screen is manufactured using
high-precision technology. However,
some tiny black points and/or bright
points (red, blue or green in colour) may
constantly appear on the LCD screen.
These points are generated in the
manufacturing process and are normal.
To Next Page
Loading...
Need help?
General
