14
Adjusting Rinse Aid Reservoir
The rinse aid reservoir has six settings. Both the recommended setting and the factory setting is "4". If the
dishes are not drying properly or are spotted, adjust the dial to the next higher number until your dishes
are spot-free.
Adding Rinse Aid
Rinse aid helps to ensure water does not cling and leave marks on crockery during the drying phase and
helps crockery dry faster after it has been washed. Only pour rinse aid that is for domestic dishwashers into
the reservoir. This model is designed to use liquid rinse aid only.
Please follow the steps below to pour the rinse aid into the storage reservoir, and the amount will dispense
automatically.
1. Turn the cap and open. When the cap open marking is
aligned, you may lift the cap up.
2. Pour the rinse aid until the rinse aid indicator turns
completely black in colour and close the cap.
3. Be careful not to overfill the reservoir. Wipe up any spills.
• Rinse aid refill indicator will illuminate when the reservoir is running out of rinse aid and requires
refilling.
• Alternatively, you can judge the amount of rinse aid by checking the rinse aid indicator next to the
reservoirs cap when the indicator is black, it means it is full. When it is clear, it means it is almost
empty.
• If the water hardness in your area is soft, you may not need rinse aid as it may cause white film to
develop on your dishes.
• If there are some rinse aid residue left in the washing compartment or your dishes, please turn the
rinse aid dispenser dial to 1.
• If you decide to use a detergent tablet, you do not need to add rinse aid into the rinse aid reservoir.
* images are for Indication only; please refer to your individual model for actual details.
SDW60B12_IB_120522_Funnel Image_Pauline.indd 14 12年5月22日 下午10:36
To Next Page
Loading...
Need help?
General
