24
Spray Arms
cleaned regularly.
1.
External Care
Filtering System
The filtering system in the base of the wash cabinet retains coarse debris from the washing cycle. The
collected coarse debris may cause the filters to clog. Check the condition of the filters regularly and clean
them if necessary under running water.
Please follow the steps below to clean the filters in the wash cabinet.
1. Ensure the dishwasher is switched off.
2. Turn the coarse filter anti-clockwise and gently lift it out.
3. Gently lift the main filter and the fine filter with care.
4. Rinse all the filters under running water, including the filter cylinder, and then refit all filters in the
reverse order.
5.
Ensure the dishwasher is switched off.
2. Check whether or not the holes for the upper and lower spray arms are clogged. If there is any
clogging, remove the spray arms and clean them under running water.
3. You can remove the lower spray arm by pulling it upwards, while the upper spray arm nut can be
removed by turning the nut to the left.
4. Ensure that the nut is correctly fitted and turned to the right when refitting the upper spray arm.
* Images are for indication only. Please refer to your individual model for details.
SDW60B12_IB_120522_Funnel Image_Pauline.indd 24 12年5月22日 下午10:36
• Do not over tighten the filters.
• Put the filters back in sequence securely, otherwise coarse debris could get into the system and
cause a blockage.
• WARNING: NEVER use the dishwasher without filters in place. Improper replacement of the filter
may reduce the performance level of the appliance and damage dishes and utensils.
To Next Page
Loading...
