Sandstrom SDW60W10N - Unloading the Dishwasher; Delay Start; Half Load

24
GB
Unloading the Dishwasher
Allowing dishes to cool down before unloading is important as dishes tend to break and chip more easily
when they are hot. Therefore, if you open the dishwasher door fully after switching off, it will allow the
dishes to cool down much faster.
We suggest:
Unload the lower basket first, followed by the cutlery basket and then the upper basket.
This will prevent water drops from the upper basket from falling onto the dishes in the lower basket.
Delay Start
The starting time of a washing programme can be delayed and adjusted.
Please follow the steps below.
1. Open the dishwasher door and load your soiled dishes and crockery.
2. PresstheON/OFFbuttontoturnonthedishwasher.
3. Select your preferred programme.
4. Press the “delay start” button.
5. Set the required delay start time using the “delay start” button.
Each press of this button increases the delay start time by 1 hour increments.
6. Close the door and the unit will start the programme at the assigned time automatically.
Half Load
In case you do not have enough dishes for a full load, the half load option can be selected for washing with
upper spray only. Load the dishes in the upper basket only. This will bring about a savings in hot water and
electricity. Please follow the steps below.
1. Open the dishwasher door and load your soiled dishes and crockery onto the upper basket.
2. PresstheON/OFFbuttontoturnonthedishwasher.
3. Select your preferred programme.
4. Pressthe“1/2”button.
5. Close the door and the unit will start the programme with upper spray only.
SDW60W_X10N_IB_5L_100921.indb 24 21/09/2010 5:51 PM