8
GB
INSTALLATION
5. Ensure there is clearance each side of the
unit to allow slight sideways movement for
servicing when required. Good levelling is
essential for correct closure and sealing of
the door. When the unit is correctly levelled,
the door should not catch the inner liner on
either side of the cabinet. The adjustable feet
may be loosened or tightened in order to
obtain the optimum levelling of the unit.
6. If required, the worktop of the dishwasher
can be removed. The height without the
worktop is 820 mm. The above figure outlines
the minimum dimensions required to
accommodate the dishwasher within fitted
kitchen furniture units.
Do not connect the unit to the mains before
installation. Ensure you are not installing the
unit right in front of the mains. This is to avoid
potential damage to the back of the unit.
7. The condensation strip must be fitted to the underside of the worktop above your dishwasher to
protect it against any moisture. Its purpose is to protect your worktop’s underside from steam rising
from the dishwasher.
- Ensure the surface is clean prior to sticking the condensation strip to the underside of the
worktop.
- Remove the backing paper from the condensation strip.
- Stick the condensation strip to the underside of the worktop.
Failure to attach the condensation strip could result in damage to the underside of your
worktop!
Leave some space
Stick the Condensation
Strip under the worktop,
where you want to install
the dishwasher.
600
600
820
30
820
600
620
80
level
level
level
level
Unit in mm
SCREW
CONE GEAR
SDW60W_X10N_IB_5L_111021_ELabel.indb 8 11年10月21日 下午6:54
To Next Page
Loading...
Need help?
General
