Sandstrom SIWC46B15E - Operation; Powering the Wine Cooler; Temperature Zone Adjustment

GB
18
If you are concerned that the temperature display of wine
cooler is not correct and wish to check the temperature you
will need a special fridge/freezer thermometer. You may also
need a hygrometer to check the humidity of your wine cooler.
These are available from most supermarkets and hardware
shops.
Place the thermometer and hygrometer on the middle shelf of
the wine cooler, where it can be read easily. Leave overnight,
compare the temperature of the thermometer and the display
in the wine cooler. The humidity in the wine cooler should be
between 50%-80% RH depending on the type of wine.
Operation
Switching On or O Your Wine Cooler
Press and hold and to switch on or o the Wine Cooler.
Adjusting the Upper and Lower Zone Temperature
The temperature of the upper zone and lower zone needs to be set individually. Press once,
the display will show the default temperature setting.
• Press
again, the upper zone display will ash. Press / to adjust the temperature.
• Press
again, the lower zone display will ash. Press / to adjust the temperature.
Changing between Fahrenheit and Celsius
Press and hold and to change the temperature unit.
Switching On or O the Interior Light
Press to switch on or o the interior light.
When you use the wine cooler for the rst time or restart the wine cooler after having been shut o for a
long time, there could be a few degrees variance between the temperature you select and the one indicated
on the display. This is normal and is due to the length of the activation time. Once the wine cooler is running
for a few hours everything will be back to normal.
SIWC46B15E_IB_5L_150316_grace.indb 18 16/3/15 10:21 am