Sangean DDR-66BT - Presetting Stations in DAB and FM Modes

69
Stereo / Mono switching
If the FM radio station being listened to has a weak signal, some hiss may be audible. It is possible
to reduce this hiss by forcing the radio to play the station in mono rather than stereo.
1. Press the Radio button as needed to select the FM radio mode display and tune to the required
FM station as previously described.
2. Press and hold the Menu button to enter the FM menu.
3. Press the Folder Up or Down buttons until 'Audio setting' is highlighted on the display. Press
the Select button to enter the audio setting mode. The current setting is indicated with an
asterisk.
4. To switch to mono in order to reduce the hiss from a weak FM signal press the Folder Up or
Down buttons until 'YES' is highlighted. Press the Select button to conrm the setting.
Alternatively, to return to the normal automatic 'stereo or mono' mode press the Folder Up or
Down buttons until 'NO' is highlighted. Press the Select button to conrm the setting.
5. Press and hold the Menu button to return to the normal FM mode display.
FM
radio
FM Radio
FM
Scan setting
Audio setting
System settings
Main menu
Listen in Mono only?
FM weak reception
Listen in Mono only?
FM weak reception
>
>