GB
72
Inserting a CD
Ensure the CD player is empty before inserting a disc. If there is a disc in the player then the CD
indicator will be lit. If you cannot insert a disc, press the CD Eject button to remove the CD currently
in the player.
1. Press the Standby button to switch on your radio.
2. To select the CD mode press the Media button until 'CD' shows on the display.
3. To eject a CD press and release the CD Eject button. To reload a CD that has just been ejected,
press the Eject button a second time.
4. Insert a disc with printed side facing up into the CD slot. The disc will be loaded automatically.
The unit will check the CD type and load its track list. The display will show 'Loading' and then
'Reading' as the information is read.
5. If you load a disc containing MP3 or WMA les your radio will enter the MP3/WMA mode.
Playing a CD
1. Press the Play/Pause button to start playing the disc. The display will show the rst track number.
2. Adjust the Volume to the required setting.
3. To pause playing press the Play/Pause button. To resume press the Play/Pause button again.
4. To stop play, press the Stop button. The total number of CD tracks and the word "Stop" will
be
displayed. If you put the unit into standby mode without pressing the Stop button, then the
next time the unit is switched on it will return to the previously played track.
5. To take out the CD, press the CD Eject button. The display will show 'Eject'. In order to protect
the disc if it is not removed, the unit will reload the CD after 10 seconds and then enter standby
mode.
CD 12:34
Readiong
CD 12:34
T001 00:03
Playing
CD 12:34
T001 00:07
Playing
CD 12:34
T001 43:00
Stop
To Next Page
Loading...
