4
GB
Antenna / Earphone
Insert the earphone into the earphone jack. The cord
connecting the earphone to the receiver acts as
an antenna during FM audio reception and should
be extended as much as possible to increase the
sensitivity.
A built-in ferrite bar antenna is provided for AM
reception and it is only necessary to rotate the radio
for maximum signal strength during AM listening.
Volume Control
Use the volume control to adjust volume level.
Display will show the changes when you operate the
volume control.
Tuning the radio
Band AM
Frequency DT-120 522-1710 kHz (9kHz)
Antenna DT-120 520-1710 kHz (10kHz)
Internal/rotate radio for best reception
Band FM
Frequency 87.50-108 MHz
Antenna External/Make sure the earphone in
plugged into earphone jack
To Next Page
Loading...
