7
CHOOSING A POWER SUPPLY
This radio can be operated using: 4 Alkaline UM-1 (D size)
batteries AC power (230V/50Hz)
INSTALLING BATTERIES
(1) Position the radio face down.
(2) Press the catch and pull out the cover of battery compartment.
(3) Insert 4 UM-1 (D size) batteries.
(4) Replace the battery cover.
BATTERY REPLACEMENT
The battery indicator will display the battery level for
approximately 7 seconds after radio is switched on. The battery
indicator will show when the battery in full power level.
When Display battery indicator shows , the batteries
should be replaced. After removing the batteries, you have
approximately 3 minutes to replace the batteries after which
clock and memory information will be lost.
USING THE AC LINE-IN
Before plug the AC cord into AC socket, make sure the AC
voltage is 230V AC/50Hz.
The AC cord should be disconnected from the mains supply
when not in use.
SETTING THE CLOCK
The clock will start running when the batteries are installed or
AC power is plugged in. The display will show “0:00”and real
time symbol “ “.
To Next Page
Loading...
