Saniflo SANISPEED - User Manual

1. Description
This unit is a pump that will clear the waste from a shower and washbasin, bath, washing machine, glass washer and a sink in a light commercial
situation.
The unit will start automatically.
Please pay particular attention to the following:
Possible danger to personnel
Warning of possible electrical hazard
“ATTENTION” This is a general warning that failure to follow instructions could result in poor functioning of the unit.
This equipment benefits from the latest technological innovations concerning soundproofing. To benefit fully from the advantages provided by
this new generation of appliances, it is important to comply with the installation instructions in section 5.
2. List of Accessories included
A B C
E F G
I
x2
Discharge elbow
D
Air vent cover
Metal hose clip Metal hose clip
Metal hose clip
H
Floor mounting screws
Floor mounting bracket
End cap
Rubber connector
x2
x6
x1
40 x 60mm
x1
x1
x2
x1
x3
32 x 50mm25 x 40mm

Summary

Description and Safety

Safety Warnings

Highlights potential dangers from personnel and electrical hazards.

List of Accessories

Dimensions and Measurements

Performance Curve and Discharge Pipe Guide

Installation and Connections

Side Inlet Connections

Details on how to connect pipes to the unit's side inlets.

Lid Inlet Connections

Instructions for connecting pipes to the unit's lid inlets.

Appliance Connections and Discharge

Connecting Bathroom Appliances

Guidance on connecting various bathroom fixtures to the unit.

Discharge Pipe Considerations

Technical advice for proper discharge pipe setup and fall.

Servicing and Maintenance

Electrical, Norms, and Care

Electrical Connection Procedures

Instructions for safe and compliant electrical wiring.

Care and Use Guidelines

Recommendations for operating and maintaining the unit.

Dismantling and Guarantee

Parts Identification

Saniflo SANISPEED Specifications

General

Power	400W
Max Flow Rate	100 L/min
Inlet Diameter	40mm
Motor RPM	2800 RPM
Horsepower	0.54 HP
Power Consumption	400W
Protection Rating	IP44
Maximum Fluid Temperature	40°C
Max Temperature	104 °F (40 °C)
Discharge Pipe Diameter	22 mm
Voltage	230 V