6
www.sanitairecommercial.com
EN
FILLING THE SOLUTION TANK
WARNING
Fill with warm (140°F/60°C MAX) tap water and add the recommended formula.
DO NOT USE BOILING WATER. DO NOT HEAT WATER OR TANK IN MICROWAVE
.
1
4
5
2
3
The solution tank
is located on
the back of the
floor washer.
Lift the solution tank
straight up to remove from
the floor washer.
Only for Sanitaire solution:
1. Fill solution tank with 5 ounces of Sanitaire
cleaning or sanitizing solutions.
2. Fill the remainder of the solution tank with
warm tap water to Maximum Fill Line.
(Water to solution ratio = 6:1)
For other recommended solutions:
1. Fill solution tank with "ready to use"
(pre-diluted) formula to Maximum Fill Line.
2. Follow manufacturers recommended
solution ratio for cleaning and sanitizing
hard floors.
Unscrew the cap from the
solution tank.
6
Screw the cap back onto the solution tank.
On the back of the floor
washer, align solution tank
with the grooves and slide
tank into place until you
hear a click.
click!
To Next Page
Loading...
