Sanitaire SC7500 Series User Manual

6
Attaching the handle to the
vacuum cleaner
• The vacuum cleaner and the handle are packed
separately and require assembly.
• Remove the handle bracket by removing the two
screws (Fig. 1).
• Place handle onto the back of the vacuum,
aligning holes with pegs (Fig. 2).
• Place the handle bracket back into position
(Fig. 3).
• Secure with two screws removed in Fig. 1. Tuck
the cord into the cord retainer to the left of the
handle.
• Open the bag compartment to ensure a
vacuum bag is in place.
E
NGLISH
www.sanitairecommercial.com
How to assemble
What’s in the carton
Contenu de la boîte
Contenido de la caja
O
wn
e
r
’
s
Gu
id
e
1
3
CAUTION
D
o not insert the battery or turn on the
vacuum until it is completely assembled.
!
Charging the battery charger
and battery pack
• When you receive your vacuum, the battery pack
is partially charged and will run for a short time.
The battery pack is located on the back of the
vacuum. It can be charged while installed on the
vacuum (see page 8), or the battery pack can be
removed from the vacuum and charged
independently (Fig 4).
• Plug the AC Cable into the battery charger and
into a wall socket (Fig. 4).
• Plug the DC Cable into the battery charger
(Fig. 5).
• Plug the DC cable into the charge point on the
battery pack (Fig. 6).
• The charger LED light will be red during charging
and will turn green when the battery pack is fully
charged.
AC cable / Câble c.a. / Cable CA
DC cable
Câble c.c.
Cable CD
2
4
5
6
1618138_rev1_BislSanitaireOG_SC7500.qxp_Layout 1 1/18/19 2:33 PM Page 6

Sanitaire SC7500 Series Specifications

General

Brand	Sanitaire
Model	SC7500 Series
Category	Vacuum Cleaner
Language	English