Need help?Do you have a question about the Sansui 1000X and is the answer not in the manual?
General| Tuning range | FM: 87 to 108 MHz, MW: 535 to 1605 kHz |
|---|---|
| Input sensitivity | 2.5mV (MM), 150mV (DIN) |
| Signal to noise ratio | 70dB (MM) |
| Output | 150mV (line), 30mV (DIN) |
| Speaker load impedance | 4Ω to 16Ω |
| Type | Stereo Receiver |
Identifies specific locations for measurement during alignment procedures.
Step-by-step guide for aligning the FM reception circuits.
Detailed steps for aligning the FM multiplex stereo circuits.
Step-by-step guide for aligning the AM reception circuits.
Lists components and their positions for the tone control circuit.
Lists components and their positions for the equalizer amplifier circuit.
Lists components and their positions for the ripple filter circuit.
Lists components and their positions for the power supply circuit.
Lists components and their positions for the multiplex stereo decoder.
Lists components and their positions for the FM Intermediate Frequency amplifier.
Lists components and their positions for the AM Intermediate Frequency amplifier.
Lists components and their positions for the driver amplifier stage.
Specific bulletin detailing a modification for the stereo indicator brightness.
To Next Page
