Need help?Do you have a question about the Sansui 5050 and is the answer not in the manual?
General| Total Harmonic Distortion | 0.3% |
|---|---|
| Damping Factor | 30 |
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Signal to Noise Ratio | 80dB (line) |
| Dimensions | 355 mm |
| Tuning Range | FM: 88 MHz to 108 MHz, AM: 530 kHz to 1605 kHz |
| Channel Separation | 50dB (1kHz) |
| Output | 150mV (line) |
| Speaker Load Impedance | 4-16 ohms |
| Speaker Impedance | 4 to 8 ohms |
Schematic representation of the main functional blocks of the receiver.
Procedure for adjusting bias current for L-CH and R-CH using DC Volt Meter.
Procedure for FM and MPX adjustment and alignment using signal generators.
Procedure for AM IF adjustment and tracking using signal generators.
Location and parts list for the tuner circuit board (F-2590).
Complete schematic diagram for the Sansui 6060 model.
Complete schematic diagram for the Sansui 5050 model.
Block diagram illustrating the power amplifier and protector circuit operation.
Block diagram of the AM/FM tuner section, including IF and MPX stages.
To Next Page
