Need help?Do you have a question about the Sansui G-9700 and is the answer not in the manual?
Guidelines for safely placing the audio unit in its environment.
Instructions for correctly wiring audio components and cables to the unit.
Requirements for ensuring adequate airflow around the audio equipment.
Advice on using appropriate cleaning materials for the unit's panel and cabinet.
Guidance on connecting indoor and outdoor FM antennas for optimal reception.
Details on using 300-ohm and 75-ohm terminals for FM antenna hookups.
Instructions for connecting an AM antenna for improved reception.
Safety precautions for connecting speaker wires to prevent hazards.
How to connect a turntable to the unit's PHONO or TAPE/AUX inputs.
Guide to connecting tape decks to the unit's TAPE REC and TAPE PLAY terminals.
Description of the main power switch and its operational indicators.
How to select which speaker system (A or B) receives audio output.
Instructions for connecting headphones for private listening.
How to choose the desired audio source for playback.
How to tune into AM or FM radio stations using the tuning knob.
Displays the signal strength of received radio stations.
Indicates optimal tuning position for FM broadcasts.
Adjusts the overall sound output level of the audio system.
Adjusts the sound balance between left and right speakers.
Input jack for connecting a microphone to the unit.
Adjusts the input level for microphone signals.
Enables or disables the tone control circuits for audio adjustment.
Adjusts the low-frequency (bass) response of the audio.
Adjusts the mid-frequency response, like human voice.
Adjusts the high-frequency (treble) response of the audio.
Enhances bass and treble at low volumes for more realistic sound.
Reduces super-low frequency noise from warped records.
Reduces high-frequency noise like record scratches or tape hiss.
Instantly reduces volume by 20 dB for temporary muting.
Displays real-time peak output power levels to 8-ohm speakers.
Selects the scale range for the power meters.
Sets the power meters to display PEAK or HOLD values.
Selects FM reception mode (AUTO stereo/mono or MONO).
Adjusts IF bandwidth (WIDE or NARROW) for optimal FM reception.
Automatically reduces noise for weak-signal FM broadcasts.
Enables Dolby FM broadcast processing for correct audio response.
Selects tape playback, recording, or monitoring modes.
Allows listening to the selected program source during tape operations.
Step-by-step guide to setting controls and switches before initial power-up.
Tips to resolve issues like noise, hum, or howling during vinyl playback.
Guidance on achieving optimal tuning and volume for AM stations.
Tips for optimal FM tuning, noise reduction, and Dolby FM.
How to reduce high-frequency hiss and other tape playback issues.
Steps for preparing and executing recording from sources to tape.
Instructions for copying tapes from TAPE-2 to TAPE-1.
Recommended microphone types and impedance considerations.
Explains and offers solutions for audio feedback (howling).
Addresses signal reflections causing distortion and how to align antennas.
Tips for improving signal-to-noise ratio with weak antenna signals.
Advice on minimizing noise from electrical interference sources.
Strategies for enhancing volume and clarity for weak AM signals.
Troubleshooting common AM noise issues like interference and hum.
Guide for dubbing tapes between decks connected to TAPE/AUX.
Explains the unit's protection system and actions upon activation.
Technical details on power output, distortion, frequency response, and impedance.
To Next Page
General
