Sansui G-9700 - Front Panel Controls: Tuning and Signals; TUNING Control; SIGNAL Indicator; TUNE Indicator

16
VOLUME
50
40 60
BALANCE
30 70
2 0 2
4 4
20 80 P Fi
8 8
10 90
LEFT RIGHT
MIC MIXING
LEVEL
4 5 ¢
5 TUNING Control
Use
it
to
tune
in
on
the
frequency
of
a
desired
AM
or
FM
station.
6 SIGNAL Indicator
It
indicates
the
signal
strength
at
the
antenna
input
terminals
of
a
re-
ceived
AM
or
FM
station.
7 TUNE Indicator
The
optimal
tuning
position
for
FM
broadcasts
is
achieved
when
the
round
indicator
light
in
the
center
of
the
TUNE
indicator
lights
up.
When
tuning
slips
slightly
from
the
optimal
tuning
position,
the
round
indicator
light
goes
off
and
one
of
the
triangular
indicators
at
the
left
and
right
of
the
round
indicator
light
comes
on.
The
triangular
indica-
tor
lights
point
in
the
direction
the
tuning
control
should
be
moved.
When
tuning
slips
totally
from
signal,
triangular
indicator
lights
also
go
off.
e@ TUNE tndicator is not in operation during AM reception.
8 VOLUME Control
It
adjusts
the
output
level
(volume)
of
your
audio
system.
The
more
to
the
right
it
is
turned,
the
greater
the
volume.
9 BALANCE Control
The volume of the left and right speakers can be adjusted by the
BALANCE contro}. As the control is turned counterclockwise from the
center position, the sound from the left speaker becomes louder than
that from the right speaker, and vice versa. Adjust so that the sounds
from the left and right speakers are heard with equal volume at your
listening position. : .
10 MIC Jack
11 MIC MIXING LEVEL Control
Insert a microphone plug into the front-panel MIC jack and adjust its
level with the MIC MIXING LEVEL control. You can mix microphone
sounds with other program sources. (Refer to page 36).
@ When no microphone is used, be sure to turn its control fully
counterclockwise to the ‘’0” position.