Need help?Do you have a question about the Sansui QRX-4500 and is the answer not in the manual?
General| Type | Quadraphonic Receiver |
|---|---|
| Total Harmonic Distortion | 0.5% |
| Tuning Range | FM: 87.5 - 108 MHz, AM: 530 - 1600 kHz |
| Inputs | Phono, AUX, Tape |
| Outputs | Tape out |
| Dimensions | 540 x 161 x 351mm |
| Weight | 16200 g |
| Input sensitivity | 2.5mV (MM), 150mV (line) |
| Signal to noise ratio | 70dB (line) |
| Channel separation | 40dB |
| Speaker load impedance | 4 to 16 ohms |
| Frequency Response | 20Hz to 20kHz |
Controls receiver power and rear AC outlet.
Selects between 2-channel and 4-channel operating modes.
Selects program sources like PHONO, FM, AM, AUX.
Guides connection of speaker systems and impedance/polarity.
Instructions for turntable choice, connection, and record playback.
Steps for tuning FM and AM stations and optimizing signals.
Recording, playback, and connection procedures for 2-channel decks.
Instructions for dubbing tapes between two connected decks.
Step-by-step guide for recording and playback.
Explains recording/playback of 4-channel tapes.
Steps for disassembling the receiver's wood case, front panel, and bottom board.
Procedure for removing and disconnecting the tuner block.
Steps for adjusting current levels during alignment.
Detailed steps for aligning the FM section.
Alignment procedure for the FM multiplex circuit.
Steps for adjusting output levels during alignment.
Detailed steps for aligning the AM section.
To Next Page
