Sansui G-9700 - Listening to Radio Broadcasts; AM Reception; FM Reception

Listening to radio broadcasts
1. Set the SELECTOR switch to FM AUTO or AM (to FM AUTO to
receive an FM broadcast, to AM to receive an AM broadcast).
2. Adjust the TUNING control! and tune in the desired station.
AM Reception
Optimal tuning is achieved when the rightmost SIGNAL indicator
light comes on.
FM Reception
Optimal tuning is achieved when the rightmost SIGNAL indicator
light and the round indicator light in the center of the TUNE
indicator come on. If the left or right TUNE indicator light comes
on, tuning has slipped somewhat. Turn the tuning contro} in the
direction pointed to by the triangular indicator light until the round
TUNE indicator light comes on.
After optimal tuning is achieved, the DIGITALLY QUARTZ
LOCKED System goes into operation to ensure continuously
accurate tuning. The QUARTZ LOCKED indicator light shows that
this system is in operation.
e If you hear the noise caused by the interference of neighboring
stations, try setting the FM IF BAND switch to the NARROW
position. If you don't, use the WIDE position to ensure optimum
hi-fi FM reception.
@ When the FM AUTO NOISE FIL ter) switch is kept at ON, you'll
get clean reception with little noise, even from weak-signal stations.
@ To receive a Dolbyized FM broadcast, set the DOLBY FM DE-
EMPHASIS switch to ON, turn on the Dolby NR (decoder) adaptor
you've connected to the TAPE-2 terminals on the unit, and set the
TAPE FUNCTION switch to TAPE-2.
e@ tf you haven't connected a Dolby NR adaptor to the unit, but want
to receive Dolby FM broadcasts, set the DOLBY FM DE-EMPHASIS
switch to OFF; you can enjoy such broadcasts with no appreciable
loss of high fidelity.
3. Adjust the unit’s other controls and switches to suit the type of
music you are going to hear.
ooo
OrO
o00000
ed000
SELECTOR
FM AUTO
4
I= a
o00q00 0 000
2000 Oe