Sansui G-9700 - Speaker System Setup; Speaker Connection Safeguards; Turntable Connection; Tape Deck Connection

10
Q @
Speaker systems
To SPEAKER SYSTEM-A or B terminals, connect speaker cords taking
care not to confuse the right channel with the left, the plus polarity
with the minus.
Important safeguards
To prevent possible fire or shock hazards, be sure to follow safeguards
when connecting speaker leads.
* Be sure to turn the power off or disconnect the power cable.
The ends of the cord should be peeled to a length of 10 mm, and in
order to prevent the wire strands from getting out of line, the wire
strands should be twisted and inserted in the unit’s SPEAKER
terminal hole, making sure that the bare portion of the cords is fully
and completely entered.
Also be sure refer to the instructions accompanied with your
speaker systems while connecting cords to the speaker terminals.
*
Turntable
Connect your turntable to the PHONO terminals. If your turntable is
equipped with a grounding cable, connect it to the unit's GND termi-
nal. But disconnect it if you notice increased hum.
e if your turntable has a crystal or ceramic cartridge, connect it to
TAPE/AUX inputs, not PHONO inputs.
Tape deck
You can connect up to two tape decks to the unit. Connect the unit’s
TAPE REC terminals to the line input terminals of your tape deck, and
the unit's TAPE PLAY terminals to the output terminals of the deck.
+.