Need help?Do you have a question about the Sansui 881 and is the answer not in the manual?
General| Power Output | 60 watts per channel into 8Ω (stereo) |
|---|---|
| Frequency Response | 10Hz to 30kHz |
| Signal to Noise Ratio (MM) | 70dB |
| Tuning Range | FM, MW |
| Damping Factor | 50 |
| Input Sensitivity (MM) | 2.5mV |
| Input Sensitivity (Line) | 150mV |
| Channel Separation (MM) | 50dB |
| Channel Separation (Line) | 50dB |
| Output (Line) | 150mV |
| Speaker Load Impedance | 4-16 ohms |
| Total Harmonic Distortion | 0.1% (at rated power) |
Procedure for adjusting the DC offset and bias current on the driver circuit board.
Steps for aligning the FM Intermediate Frequency (IF) stages for optimal performance.
Procedures for calibrating the FM dial, reducing mono distortion, and performing RF alignment.
Steps for aligning the Multiplex (MPX) section for proper stereo separation and decoding.
Procedures for aligning the AM Intermediate Frequency (IF), dial, and Radio Frequency (RF) stages.
Identifies common power supply issues, check points, and potential causes for the receiver.
Guides for diagnosing and resolving problems within the audio circuitry of the receiver.
Steps for diagnosing and resolving issues related to the AM/FM tuner reception.
Identifies components and their locations on the F-1507 Tuner Circuit Board.
Lists and locates components for the F-1519C FM Pack circuit board.
Details components and their placement on the F-2433 Equalizer Circuit Board.
Identifies parts and their locations on the F-2432 Input Terminal Board.
Lists and locates components for the F-2434 Tone Control Circuit Board.
Identifies components and their placement on the F-2435 Filter Circuit Board.
Details components and their locations on the F-2436 Driver Circuit Board.
Lists and locates components for the F-2437 Power Supply Circuit Board.
Lists and identifies various front panel components and hardware.
Identifies components located on the top side of the chassis.
Lists and identifies components found on the bottom side of the chassis.
Step-by-step guide for correctly threading the dial cord onto the tuning mechanism.
Instructions for attaching the dial pointer to the dial scale for accurate tuning indication.
To Next Page
