Sansui AU-719 - Precautions; Installation and Ventilation; Connection Guidelines

For the United Kingdom only
Important
The wires in this mains lead are coloured in accord-
ance with the following code:
Blue: Neutral
Brown: Live
lf the colours of the wires in the mains lead of this
equipment should not correspond to the coloured
markings identifying the terminals in your plug, pro-
ceed as follows:
The wire which is coloured blue must be connected
to the terminal which is marked with the letter ‘N’
or coloured black.
The wire which is coloured brown must be connected
to the terminal which is marked with the letter ‘L’ or
coloured red.
Ensure that your equipment is connected correctly.
lf you are in any doubt, consult a qualified electrician.
For equipment purchased outside the U.K. with a
“EUROPEAN” two-pin mains plug, the plug should
be removed and connections made in accordance with
the above instructions. Ensure also that the equipment
is properly adjusted to 240 volts operation. If you are
in any doubt, consult a qualified electrician, or our
Service Agent in the U.K.
Precautions
Installation
*
Never install the unit in dusty or humid locations, or in close
proximity to heating appliances. Also, do not place it near a flower
basin or fish bowl, for accidental spillover may cause fire, elec al
shock and/or breakdown.
Keep the unit away from TV sets to avoid buzz noise.
When mounting the unit on a shelf, be sure that its supports are
solidly fixed.
Do not remove the cabinet cover or bottom board of the unit.
Ventilation
*
*
Install the unit where there is a good circulation of air.
Do not obstruct the ventilation opening of the cabinet.
Connection
*
When connecting or re-locating the unit, be sure to turn the power
off or disconnect the power cable.
Be sure not to confuse the right channel with the Jeft, plus cables
with minus or inputs with outputs. Check each step carefully.
Use connection cords of dependable quality. Check that connec-
tions are secure and that leads of connection are not frayed or in
contact with other objects. Poor connection may cause hum noise
or breakdown.