Sansui RX-710 - FM Band Switch; EJECT;Fast Wind Switches; METAL Switch; Dolby NR Switch

9 FM Band Switch
When the FM switch is depressed, the FM indicator lights up and the
radio may be tuned to stations broadcasting on the FM band. Each time
the FM switch ts depressed the FM indicators 1, 2, and 3 will light up
in Sequence:
10 EJECT/Fast Wind Switches
To retrieve a tape, depress the EJECT ( << and >> ) switches simultane-
ously. The tape will be ejected and the unit will switch over to radio
reception automatically. To wind a tape quickly (fast forward) depress
the switch in the same direction as the PRO-indicator lamp, and to re-
wind it, press it in the opposite direction. The tape will playback at the
beginning or the end automatically.
To stop the tape in the middle during either fast forward or rewind, lightly
depress the alternative switch.
* To maintain the pinch roller in optimum condition, always depress
the EJECT switches and remove a tape from the unit when either
the unit or the ignition is switched off.
11 METAL Switch
The metal switch is used with metal tapes or high bias position tapes.
When the switch is depressed, the indicator lights up. Leave the switch
_in the released position when playing normal tapes. When the switch
is in the released position, the indicator will go out. |
12 Dolby NR Switch ( 00 )
Push this switch to the ON position (indicator lights) when playing back
tapes which have been recorded using the Dolby noise reduction |
system”. This will reduce the amount of high-frequency tape hiss in-
herent to tapes and enhance the sound quality.
Keep
the
switch
at
OFF
(indicator
is
off)
when
playing
back
ordinary
tapes
whieh were not recorded using the Dolby system.
Noise
reduction
system
manufactured
under
license
from
Dolby
Laboratories Licensing Corporation.
-*
“Dolby’”’
and
the
double-D
symbol
are
trade
marks
of
Dolby
Labora-
tories Licensing Corporation.
73 AMPS Switch
This automatic music program search function is used to automatically
locate a program which is being played back and which you want to
hear again from the start or another program which you want to hear.
After this switch is pressed to the ON position (indicator sights), play-
back starts automatically from the following program when the tape is
fast forwarded or from the start of the program being played back when
the tape is rewound.
Remember to keep this switch at OFF (indicator is off) by pressing it
again when you do not intend to use this function.
14 BASS Control
This is used to control the low-frequency (bass) sound characteristics.
The bass control is flat at the center clickstop position. When the con-
trol is rotated clockwise, the bass is boosted and when rotated coun-
terclockwise, it is attenuated.
15 TREBLE Control
— This is used to control the high-frequency (treble] sound characteris-
tics. The treble control is flat at the center clickstop position. When
the control is rotated clockwise, the treble is boosted and when rotated
counterclockwise, it is attenuated.
16 Display
The display panel registers the following information:
Reception frequency: The frequency of the station which has been tuned
in is indicated in dights. MHz units are used for FM frequencies and
kHz units for AM frequencies.
Time: The time will be displayed in hours and minutes during tape play
back or when DISP switch is depressed while the radio is playing.
ST (Stereo) indicator: This indicator lights when an FM stereo station
has been tuned in.
ME (Memory) indicator: When the ME (Memory) switch is depressed,
the ME indicator will come alight for 5 seconds indicating that the
memory function is in operation for presetting radio stations.
11