Sansui SR-929 - Page 30

28
Record
disque
Schalfplatte
Record
disque
Schatiplatte
Lubrication
Your unit requires no lubrication whatsoever. Note that application of
oil to the unit's platter shaft or platter bearing may cause turntable
breakdown.
Arm lifter height adjustment
When the arm lifter is raised to its maximum height with the tonearm
on it, the stylus tip should be about 10 mm away from the surface of
the record. If the height is excessively greater than this figure, loosen
the screw locking the movable portion of the arm lifter using the
hexagonal wrench supplied (see the illustration at left), adjust the lifter
to the proper height, and re-tighten the screw, After the arm-lifter
height adjustment, play a record and confirm that the tonarm is not in
contact with the arm lifter when the former is lowered for play.
Arm lifter descent time
When you use your unit after a long period of disuse, the arm lifter
mechanism may tend to lower the tonearm more slowly than usual.
This may also occur in periods of temperature change, such as in the
changes of seasons. It will correct itself in time, and you may wish to
aid the descent of the tonearm with a light touch of your finger until it
does.
Horizontal balance of headshellt
The supplied headshell can be adjusted for horizontal balance as
follows: loosen the screw (—), move the headshell to the left or right to
bring it into balance, then retighten the screw.
About the rubber mat
Both surfaces of the rubber mat are treated differently. Since the
quality of the rubber mat affects the quality of reproduction, you can
enjoy two kinds of sonority by flipping the mat.