INSTALLATION.
Install the appliance on a counter which can take the weight of the appliance with the
container full.
Make sure that proper ventilation in the appliance is possible. A free space of a minimum
of 15 cm must be left at the front and back
CARE: Leave the appliance to stand without plugging in the electrical
plug for 12 hours whenever it has been laid down or turned over
during its transport or unpacking.
ELECTRICAL CONNECTION:
• The electric power supply for the appliance is available in 3 single-phase voltages:
- 110-120 V 50/60 Hz: 34V1 model
- 220-240 V 50 Hz: 34V2 model
- 220-240 V 60 Hz: 34V4 model
Line protection: the appliance should be connected to a standard 2-pole + earth electric
socket. The system should be fitted with a ground fault circuit interrupter and a fuse rated
at 10A. The appliance must be earthed.
CARE:
• Before connecting the appliance, check that the mains electrical voltage is the same
as the voltage for your machine. This value is given:
either on the identification plate on the appliance rear panel.
or on the identification plate on the last page of this manual.
• If the power supply lead is damaged, it must be replaced by a special assembly
available from approved SANTOS dealers or from SANTOS.
TURNING ON FOR THE FIRST TIME (Fig. A ).
Thoroughly clean all parts coming into contact with the food.
Wash with a standard dishwashing product: the lid (2), paddle (3) and juice container
(5).
To Next Page
Loading...