CLEANING:
IMPORTANT:
• In all circumstances, the machine should be stopped and the machine's
power supply cable (10) unplugged.
• Do not clean with a water spray or pressure jet
The ground coffee outlet tube (23) should be cleaned regularly using a commercially-
available bottle-brush (fig. H).
MAINTENANCE
Before carrying out any work on the machine, it must be unplugged from the mains and
the motor start capacitor discharged.
Discharging the capacitor:
• Unscrew the 2 screws located under the machine in the middle of the base plate
(fig. E).
• Pull the electrical components unit (26) out of the base plate.
• Using a screwdriver with an insulated handle, touch the 2 capacitor connections
(14). You should see an electric arc which means that the capacitor has been
discharged.
Spare parts:
This machine requires no specific maintenance. The bearings are lubricated for life.
If work is required to replace worn parts such as the grindstones or the electric or other
components, refer to the parts list (see exploded view at the end of the manual).
For all spare part orders (see references in the exploded view at the end of the manual),
state:
the type,
the machine serial number and
the electrical specifications (16)
recorded under the machine.
Replacing the grindstones:
IMPORTANT: always replace both 2 grindstones (9) at the same time. (use
SANTOS reference 00001B).
The 2 grindstones are identical and can be fitted equally either on the moving plate
(8) (moving grindstone) or on the adjusting nut (5) (fixed grindstone) (fig. F).
1. Close the bean shutter (6) (fig. G).
2. Run the machine until the coffee beans waiting in the grinder body have passed
through.
To Next Page
Loading...
