Need help?Do you have a question about the Sanus MLL11 and is the answer not in the manual?
General| Mount Type | Full Motion |
|---|---|
| Construction Material | Steel |
| Color | Black |
| Mounting Hardware Included | Yes |
| Cable Management | Yes |
| Warranty | 5 years |
| Swivel Range | 180 degrees |
Verify TV weight, wall type, tools, and review safety warnings before installation.
Lists TV brackets, screws, washers, and spacers for the first installation step.
Lists wall plate, anchors, washers, and lag bolts for the second installation step.
Determine the correct screw diameter (M5, M6, or M8) by threading into TV inserts.
Choose screw length based on TV back type (flat, round, inset) and cable needs.
Secure the TV brackets to the TV using selected screws and washers.
Find stud center, level wall plate, and mark hole locations for wood stud mounting.
Drill pilot holes to 3 inches deep using a 7/32 in. (5.5 mm) drill bit.
Tighten lag bolts until washers are firmly against the wall plate; do not over-tighten.
Level wall plate and mark holes for concrete mounting, adhering to thickness and block size specs.
Drill pilot holes to 3 inches deep using a 3/8 in. (10 mm) masonry drill bit.
Insert anchors, then secure wall plate with lag bolts and washers, ensuring flush seating.
Hook brackets onto the wall plate, swing down until locking tabs engage with an audible 'CLICK'.
Pull straps down, swing TV forward, then lift TV off the wall plate.
Phone numbers, email, and website for customer service and reviews.
To Next Page
