Sanus SA809 - Cut Hole for Housing

4
1 2
≤ 16 mm
(5/8 in.)
STEP 1 Cut Hole for Housing
01
CAUTION: Avoid potential personal injuries and property damage!
ƕ Drywall covering the wall must not exceed 16 mm (5/8 in.).
ƕ Box must be mounted between studs that are at least 406 mm (16 in.) apart. After installation there will not be enough space between the
SA809 and the studs for electrical wires/cables, plumbing, ductwork, or insulation. Choose your SA809 location carefully.
1. Locate the studs using an edge-to- edge stud finder. Verify the edges of the studs using an awl or thin nail. Mark the edges of the studs
with pencil.
2. Center the template
01
between the two studs. Level the template
01
and use a pencil to mark the open area of the template
01
.