Need help?Do you have a question about the Sanwa PDR4000 and is the answer not in the manual?
General| Continuity | Yes |
|---|---|
| Data Hold | Yes |
| Auto Power Off | Yes |
| Resistance Measurement | 400Ω/4kΩ/40kΩ/400kΩ/4MΩ/40MΩ |
| Capacitance Measurement | 40nF/400nF/4µF/40µF/100µF |
| Display | 4000 count |
Explains the meaning of safety symbols used in the manual and on the product for safe operation.
Provides critical instructions to prevent personal injury such as burns and electric shock during use.
Details the maximum rated input values and overload protection for different measurement functions.
Details the procedure for measuring interference voltage (ACV) before earth resistance testing.
Details the preparation, interference voltage check, and measurement steps for the 3-pole method.
Details the setup and electrode placement required for performing 3-pole earth resistance measurements.
Explains the importance and procedure of checking interference voltage before conducting the 3-pole measurement.
Outlines the steps for performing the actual 3-pole earth resistance measurement after preparation.
Details the preparation and measurement steps for the 2-pole method using an alternative earth resistance.
Outlines the steps for performing earth resistance measurements using the 2-pole method.
Details the specific measurement ranges and accuracy specifications for ACV and earth resistance functions.
To Next Page
