VIII
Safety, Operation and Maintenance Manual-07.2016
5.3.1 Manual lubrication ..................................................................................................... 5-12
5.3.1.1 Manual lubrication.............................................................................................. 5-12
5.3.1.2 Manual concentrated lubrication...................................................................... 5-12
5.3.1.3 Manual disperse lubrication.............................................................................. 5-13
5.3.1.4 Recommended grease...................................................................................... 5-14
5.3.2 Automatic lubrication system................................................................................... 5-15
5.3.2.1 Automatic lubrication system............................................................................ 5-15
5.3.2.2 Manual lubrication.............................................................................................. 5-16
5.3.2.3 Recommended grease...................................................................................... 5-16
5.4 Wear parts........................................................................................................................... 5-16
5.4.1 Wear Parts.................................................................................................................. 5-16
5.4.2 Wear parts list ............................................................................................................ 5-17
5.5 Recommended fuel, coolant, and lubricant.................................................................... 5-17
5.5.1 Recommended fuel, coolant, and lubricant ........................................................... 5-17
5.5.2 Selection of lubricating grease material ................................................................. 5-19
5.5.3 Service capacity table............................................................................................... 5-21
5.6 Standard tightening torques ............................................................................................. 5-21
5.7 Safety critical parts............................................................................................................. 5-29
5.8 Service procedure.............................................................................................................. 5-30
5.8.1 Initial 150 hours service (only after the first 150 hours) ....................................... 5-30
5.8.2 Initial 250 hours service (only after the first 250 hours) ....................................... 5-31
5.8.3 Initial 2000 hours service (only after the first 2000 hours)................................... 5-31
5.8.4 When Required.......................................................................................................... 5-32
5.8.4.1 Clean inside of cooling system......................................................................... 5-32
5.8.4.2 Check and fill the window cleaning fluid ......................................................... 5-34
5.8.4.3 Cleaning condenser........................................................................................... 5-34
5.8.4.4 Check liquid level of the coolant....................................................................... 5-34
5.8.4.5 Check the dump body........................................................................................ 5-35
5.8.4.6 Check length of suspension cylinder, check oil level .................................... 5-36
5.8.4.7 Bleeding from front brake.................................................................................. 5-37
5.8.4.8 Bleeding from rear brake................................................................................... 5-38
5.8.4.9 Selection and inspection of tires ...................................................................... 5-39
5.8.4.10 Tire inflation should be carried out away from busy working
areas................................................................................................................... 5-40
5.8.4.11 Extract lubrication sample from main reducer and differential assembly
case and final drive for checking and analysis. ............................................ 5-42
5.8.5 Check before starting................................................................................................ 5-42
5.8.6 Every 10 hours (day) service ................................................................................... 5-43
5.8.7 Every 50 hours service ............................................................................................. 5-44
Table of Contents SRT95C Off-Highway Truck
To Next Page
Loading...
