SANYI SRT95C - Page Numbers; Regulation of Use; Machine Applications; Directions of Machine

Safety, Operation and Maintenance Manual-07.2016
1-5
1.4 Page numbers
The pages in this manual are numbered as
the following:
1.5 Regulation of use
1.5.1 Machine applications
SANYI Mining Trucks are designed to be used
mainly for the following work: Traveling with a
load
1.5.2 Directions of machine
Fig.1-2
In this manual, the directions of the machine
(front, rear, and left, right) are determined ac-
cording to the view from the operator’s seat in
the direction of travel (front) of the machine.
1.6 Breaking in a new machine
Your machine has been thoroughly adjusted and tested before shipment. However, initial operation
of the machine under severe conditions can adversely affect the performance of the machine or
shorten the machine life.
Therefore, SANYI recommends that you allow a break-in period of 100 operating hours for a new
machine.
During the break-in period:
Down
Top
Left
Front
Rear
Right
Operator 's seat
SRT95C Off-Highway Truck
Introduction